Cattle and sheep dung Organic fertilizer granulator uses the current high-tech technology and is widely used. Organic fertilizer granulator is used to granulate some organic substances. It has many characteristics and is more advanced than other granulators. Before granulation, those materials do not need to be operated. Organic fertilizer granulator manufacturers, for example, must be dry. There are also swing granulators and extrusion granulators in Organic fertilizer granulators. Their principles are similar. We need to pay attention to some operations. When we first use it, we need to regularly inspect some parts to see if they are working properly. For some damaged parts, we need to check their severity and take good measures to make some changes to them. When installing the Organic fertilizer granulator, we should use anchor bolts to fix it. When installing, we should pay attention to that the machine should be at a 90 degree angle with the ground. When formally using it, we should try to use it to see if it is normal, and then we can really let it work.
Precautions for daily use of Organic fertilizer granulator:
1. When using the new machine for the first time, take 10 kilograms of grass powder (or sawdust) and 2 kilograms of fine sand, add (about 1.5 kilograms) vegetable oil or waste oil (note: it can also be replaced by grinding materials with high oil content), and mix well. Turn the gap adjustment screw until the gap between the roller and the template is between 0.1 and 0.3 millimeters. Make the two pressure rollers rotate at the same speed. Gradually add oily materials and repeatedly squeeze the squeezed particles to ensure smooth lubrication of the membrane hole. Then slowly add the required mixed materials for processing. If you feel that the membrane hole resistance is high, the production is low, or there is no discharge, you can repeatedly grind the membrane plate according to the above method to ensure smooth lubrication of the membrane hole before proceeding with processing;
2. Install the granulator stably, adjust whether the belt tightness and rotation direction are normal, and whether the screws at each part are loose. Loosen the gap adjusting screw on the roller shaft seat, so that the machine can be put into use after it is started normally without load;
3. Start the machine after adding Hyperbola Gear oil to the gearbox;
4. In the Organic fertilizer production line, if there are more refined fibers in the material processing, about 5% water should be added. If there are more refined fibers in the mixed material, the amount of water can be reduced as appropriate, and this water will be used in the extrusion process;
5. After processing, loosen the gap adjustment screws. Keep the roller in a free state, and after stopping, remove the dirt from the upper and lower storage materials, especially the remaining materials under the swing plate, to avoid damaging the bearings.