Organic fertilizer equipment is a powerful assistant in current production, and it will inevitably cause wear and tear in actual operation. Therefore, it is more important to use and maintain the equipment correctly to ensure the normal use of organic fertilizer. Below is an introduction to how to avoid malfunctions during the use of organic fertilizer production equipment.
Daily maintenance of organic fertilizer production equipment
1. Keep the workplace clean. After the completion of each organic fertilizer production equipment, the residual rubber sand inside and outside the granulation leaves and pots should be thoroughly removed. Scattered or splashed rubber sand and flying objects on organic fertilizer equipment should be cleaned up. The machine of organic fertilizer equipment should be exposed to the external processing surface, wiped clean, coated with anti rust meat paint, and applied with corresponding protective layer. Cover to prevent dust from invading again.
2. Organic fertilizer production equipment does not have external filling holes. Gears and worm gears are lubricated with organic fertilizer equipment specific grease. The upper and lower gears should be added with three in one butter every quarter. When refueling, the movable gearbox cover and the gearbox gear cover can be opened separately. Lubricating oil should drip into the sliding surface between the support gearbox and the support hinge. The worm gearbox and bearings are shipped with sufficient transmission grease, but the gearbox machine should be thoroughly cleaned once a year and all protective lubricants should be replaced.
3. Always pay attention to the operation of organic fertilizer production equipment. There should be no serious abnormal noise or metal friction noise. If any abnormalities are found, the machine should be immediately shut down for inspection. Only use after troubleshooting. Unable to check the corresponding reason, unable to start the machine. If there is a metal friction sound, you can first check the gap between the organic fertilizer equipment..jpg)
4. Regularly check the standard clearance between organic fertilizer production equipment.
5. When repairing organic fertilizer production equipment, the working gap should be re measured and adjusted several times each time to meet the standards before continuing to use.
6. If the organic fertilizer equipment of the programmable controller cannot work, check the power voltage, power plug and socket, connection plug and socket, etc., and check for internal faults in the controller.
Continuously discovering, preventing, and repairing natural degradation, enabling organic fertilizer production equipment to be repaired in potential failure states: The significance of self maintenance, through the participation of frontline employees, identifies problems in the first place and compresses them. Fully standardized production and maintenance of TNPM, advocating for the discovery and elimination of six activity sources, one of the most important links is to solve the problem of fault sources.